Be part of our community & join our international next generation forum now!
Just broke the shaft in my 2a mill. I broke it after a few years use just 4 brews ago and got a local mate to turn me up a new one on the lathe. When it came back it was a bit wonky and i had my doubts about it lasting.
If someone either owns a lathe or has access to someone who does, it would be a cheap intro into owning a mill. It's fully adjustable both ends and in good condition besides the shaft, i am replacing it because i don't have access to a turner i trust.
Make me an offer as it's much too good to throw out and i don't want to see it sitting on my shelf gathering dust.
StillDragon Australia & New Zealand - Your StillDragon® Distributor for Australia & New Zealand