So I built myself a super super reflux condenser today. I was only going to make it 300mm long but my drop saw wouldn't cut 102mm tube so it ended up 400mm. My chances of cutting a straight edge with the angle grinder are about the same as me getting married again. So 400mm it is. 9 x 19mm condenser tubes inside. I don't think i will have any problem getting full reflux with this. I plan on using it with a full flow recirculating pump in a secondary and primary cooling loop system.
I've added a 6in, 500mm section to this setup, copper pipe, going to take out a bank loan and buy all of bunnings scrubbers, I expect to visit more then one store. Im ganna add the copper pipe section for eveb more copper contact above the deflag.
Out to the shed I go. I was hoping this would fit in my warm house but its now 2.7 metres tall. And I want to order a 120 litre boiler too so its definitely not going to fit.
Yes that is a nice rig @Law_Of_Ohms. I have rig envy. A 6 inch 500mm section is going to take a lot of scrubbies. How many bunnings stores you got around you? Are those copper pipes sitting on a bubble plate?
Comments
"Mr. Clean leaves a sheen where you clean!"
I bet they weren't thinking azeotrope neutral...
https://www.youtube.com/watch?v=yifN2GOMFfc
I'm more like I am now than I was before.
So I built myself a super super reflux condenser today. I was only going to make it 300mm long but my drop saw wouldn't cut 102mm tube so it ended up 400mm. My chances of cutting a straight edge with the angle grinder are about the same as me getting married again. So 400mm it is. 9 x 19mm condenser tubes inside. I don't think i will have any problem getting full reflux with this. I plan on using it with a full flow recirculating pump in a secondary and primary cooling loop system.
Looks great. Use it in good health.
As a matter of interest, how many man hours to you have into it?
StillDragon North America - Your StillDragon® Distributor for North America
Thanks smaugy. Took me about 4 hours to cut everything and size it up and about 5 to weld It up.
I've added a 6in, 500mm section to this setup, copper pipe, going to take out a bank loan and buy all of bunnings scrubbers, I expect to visit more then one store. Im ganna add the copper pipe section for eveb more copper contact above the deflag.
will see how it goes shortly.
https://www.youtube.com/watch?v=ty6eY9VUIgI
oh, I have like 3 or 4 meters of 4in and 2in stainless pipe if someone wants some for a packed section. pm me if wanted and i'll figure out a price.
https://www.youtube.com/watch?v=ty6eY9VUIgI
Out to the shed I go. I was hoping this would fit in my warm house but its now 2.7 metres tall. And I want to order a 120 litre boiler too so its definitely not going to fit.
Nice catalyzer.
Wow, Ohms, that is a really nice rig.
Yes that is a nice rig @Law_Of_Ohms. I have rig envy. A 6 inch 500mm section is going to take a lot of scrubbies. How many bunnings stores you got around you? Are those copper pipes sitting on a bubble plate?
@Mickiboi , your solution is to install either a custom raised section of ceiling or to install a manhole cover to give you the height you need.
@TheMechWarrior a manhole sounds easy. I can do that Myself.