Be part of our community & join our international next generation forum now!
In a while I will replumb my cooling on my Dash 1.
I 'll split the output of the dephlegmator. between a 1/2" needle valve(full reflux) and a 1/4 metering valve(during take off).
So I hope to fine tune even better my cooling temp off the dephlegmator.
Now I read somewhere that it is good to control also the temp. of the product condenser. If i remember well it was about higher temp of condensed product is beneficial for escaping the higher alcohols.
If so, i would separate my cooling lines.
What are your thoughts ?