Be part of our community & join our international next generation forum now!
I hope this question does not seem too obvious, but...If I want to reconfigure my 4 plate Baby Dragon to 2 plates for a rum, do I need to get new smaller all thread rods for the new size?
Comments
You could just take 2 of the copper plates out and leave the glass sections in
What mark85 said.
But yes, new rod lengths would otherwise be the way to go.
StillDragon North America - Your StillDragon® Distributor for North America
^^^^
This
You only have to undo 4 nuts and it doesn't change your collection point.
StillDragon Australia & New Zealand - Your StillDragon® Distributor for Australia & New Zealand
Ok cheers, was not sure if removing the plates impacted in some way. Thanks
Try googling all thread coupling nuts.
Then cut your existing rods just above the second plate and boom you have a modular crystal dragon.
Thanks Dan
https://www.youtube.com/watch?v=HSkYWjL6xfw
I'm more like I am now than I was before.
Too many hours listening to Coast to Coast AM with George Noory...
I'm more like I am now than I was before.