Be part of our community & join our international next generation forum now!
I'm going to remodel my first little pot still to fit my Baby Crystal Dragon.
I have soldered the head to the pot. I will solder a 2" punkin copper to SS ferrel to the top. The bottom of the pot is flat. My question is about the flat bottom side:
If I just solder the pipe in, should I leave a few millimeters inside to act like a down comer? Boiling on the flat section. Or do I make a basic cone removing the flat bottom straight to 2"? Or leave some flat bottom, make cone to 2"?
Penny for your thought,