Be part of our community & join our international next generation forum now!
up and down loops seem kludgy and inefficient and not artsy (to me, my opinion)... maybe a water cooled plate with threaded sockets for copper rods with threaded ends... a porcupine dephleg!
What about copper tube with copper fins... this is the tubing they can gap it so it can be bent at a later date.. into a Ubend...
Finned tubes with gaps
they are soldered on, so has to be lead free, and soldered very carefully in the future... no brazing or welding.... also, would be best in a cross-flow, longitudinal fins best for vertical pipe orientation in a condenser... just sent inquiry to turbotecproducts.com about getting a couple dozen 1 foot pieces of their TruTwist tubes...
No solder here ... is a press fit copper to copper
whattya think would be best, a cross-flow condenser?
© Moonshine | 18/05/2013 | All rights reserved
StillDragon® is a registered trademark of Sperandio KG
Crystal Dragon™, Dash™ and ProCap36™ are trademarks of the StillDragon® Organization