Can someone give me a wiring diagram for the DIY Controller for use with 110v? I want to make sure I do it correctly...Thanks in advance for any help...
If I remember correctly, the wiring is exactly the same. The one hot 120V wire goes through the SSR (just like 240V on one wire in other countries). I think it needs a lower value pot is the only hardware change. That's somewhere in the big DIY thread here.
Comments
If I remember correctly, the wiring is exactly the same. The one hot 120V wire goes through the SSR (just like 240V on one wire in other countries). I think it needs a lower value pot is the only hardware change. That's somewhere in the big DIY thread here.
As @Myles said:
The neutral wire just passes through the box - unbroken if you can. The ground gets a pigtail that grounds the heatsink and SSR.
I posted a reply as well, but @law_of_ohms did some shuffling and move a few posts back to the correct location
@fadge if you can remember what you wrote then type it again :))
And quick, too, before @Law_Of_Ohms moves things around again!
Moonshine will come in and fix all his shuffling so it makes sense anyway :))
StillDragon Australia & New Zealand - Your StillDragon® Distributor for Australia & New Zealand
woops, too many home brews......
https://www.youtube.com/watch?v=ty6eY9VUIgI
I've learnt that pleasing everyone is impossible. Pissing them all off however is simple.
StillDragon Australia & New Zealand - Your StillDragon® Distributor for Australia & New Zealand