Be part of our community & join our international next generation forum now!
Hey @smaug. Are in interested in making these type of caps ?? I am still keen.
I've been traveling. Let me get back to my drawing program and I'll put something together for pricing.
Tell me some approximate measurements.
StillDragon North America - Your StillDragon® Distributor for North America
@Smaug. Sorry I forgot you were travelling. OK 2" internal diameter on the hole. THe cap will have slightly larger diameter, height of either 100mm or 150mm. Acutally if I could get a couple of 100mm and some 150mms the 100mms will fit in your standard 4" section. The 150s will be used could be used in a larger column with the typical section height of 200mm..
100mm tall cap will get you a 100mm tall downcomer cup. So your plate spacing will not be our typical distance.
BTW, I'm not so sure I can do these without satisfying an MQO. But certainly I'll find out for you.
Doesn’t the overflow go in the top hole of the ProCap? Couldn’t you just add a piece of pipe in there to extend it?
Maybe I haven’t looked at the ProCap close enough.
Actually your right. As well thinking about it using the normal bubble caps you could just extend the drain a couple of inches,or however high you want it.
But remember once the height of the liquid bed exceeds the depth of the downcomer liquid cup, you will be risking good behavior.
I like how you said that smaug. Risking good behavior. Makes you wonder about the risk word.
Yes the trap won't function correctly.
StillDragon Australia & New Zealand - Your StillDragon® Distributor for Australia & New Zealand
© Moonshine | 18/05/2013 | All rights reserved
StillDragon® is a registered trademark of Sperandio KG
Crystal Dragon™, Dash™ and ProCap36™ are trademarks of the StillDragon® Organization