Be part of our community & join our international next generation forum now!
Your Place to be >>> www.StillDragon.org <<< Home of the StillDragon® Community Forum
In this video plates start loading from the top:
https://www.youtube.com/watch?v=iOS1x8uZpUE
How can they load starting at the top?
In my plated column, its always the bottom plate that starts to load.
@rumsponge,
They load from the top because that is where the reflux condenser knocks down the initial vapor.
If yours loads bottom first, it's because the material in the lower section is cold enough to create phase change.
The latter would not likely load all of your plates in uniform order unless you only have two plates.
StillDragon North America - Your StillDragon® Distributor for North America
© Moonshine | 18/05/2013 | All rights reserved
StillDragon® is a registered trademark of IETUM LTD
Crystal Dragon™, Dash™ and ProCap36™ are trademarks of the StillDragon® Organization
Comments
In this video plates start loading from the top:
https://www.youtube.com/watch?v=iOS1x8uZpUE
How can they load starting at the top?
In my plated column, its always the bottom plate that starts to load.
@rumsponge,
They load from the top because that is where the reflux condenser knocks down the initial vapor.
If yours loads bottom first, it's because the material in the lower section is cold enough to create phase change.
The latter would not likely load all of your plates in uniform order unless you only have two plates.
StillDragon North America - Your StillDragon® Distributor for North America