Be part of our community & join our international next generation forum now!
I was running a stripping run on a 4" dash with one plate put in. I had my controller around 80%. I noticed foam starting to form in the one plate with site glass and turned the power down but the foam went through to the parrot So I then shut it down, pulled the still apart and rinsed it good. When I started it back up I was smelling a burnt smell. My question is, did I try to heat the wash up too fast. Is the burning I smell the foam I created? The product I think has a slight burnt smokey smell maybe taste but is clear maybe it's all in my head because my garage has the smell in it now.... Did I ruin the product. If I cut it with some distilled water and run it again can I get the smokey burnt flavor and smell out of it? Should I just throw it out and start again :-S Thanks for any help. ~X(